cleankat for Car
Car, Light Commercial and Duty Vehicles
Particles and Catalysts Cleaning System
Our product is found in clogged diesel particulate filters for diesel vehicles are designed to be cleaned with hot catalytic converters and filters all such organic chemaical
It consists of two stages, hot and cold. 4500 watt heating element with a fluid reservoir 20 minutes at 85 degrees Celsius sufficient amount of organic chemical is added into the heated water. absorbing heat from the engine by organic chemical tubes and passed through the particle filter. the drug from the particle filter reaches back into the hot liquid chamber through the liquid filter. This process continues until the cleaning has finished.
After the cleaning process in order to rinse the machine is connected to the city water is discharged into the same reservoir through the cold water is thrown out of the way and the evacuation of the chamber machine. Drying of the micro pores in the particle filter for the continuation of this operation by compressed air, the drying process takes place.
Particulate filter holder at the top of the machine is made by a pneumatic foot pedal system with the help Patikül filter is designed to fully comprehend.
The original catalytic converter and the particle filter recycling
1. Connect the machine power cord receptacle.
2. Connect the power cord to the compressor outlet.
3. Connect the compressor air hose to the machine rear input jacks.
4. Make the mains water connection cold water from the rear section.
5. Activate the hose to the outlet expenses.
6. Fill water to each tank.
7. Place the particle filter or catalyst pneumatic holder.
8. Turn the thermostat and heat to 85 degrees.
9. The amount needed to warm the drug reservoir “cleankat for Car” Pour the product.
10. Make sure that the upper control valve is closed.
11. Do not operate the machine from drug hot button.
12. Turn slowly observing the control valve.
13. Perform the cleaning process between 30 and 60 minutes and turn off the machine.
14. Cool the particles by opening the vent valve on the holder after cleaning.
15. Turn retaining the title of the drug reservoir.
16. Open the rear discharge valve blue.
17. Turn on the machine by turning the button cold medicine.
18. Make stop the machine for 15 minutes and rinse.
19. Dry the liquid particles in the air by opening the valve Holder
1. Connect the machine power cord to the appropriate 220-volt cable assembly.
2. Do not operate the machine without water.
3. Check all connections before operating the machine.
4. Clean water filter inside the machine after cleaning 10-15.
5. Clean the tank at the end of each cleaning expenses path.
6. Machine “cleankat for Car” to use another chemical cleaning products or products outside of our company is not responsible for any failures and problems that could otherwise.